Ultimate Guide to Indoor Training eBook
Choosing road tyres

Choosing road tyres

Home » Insight Zone

Knowledge Level: Intermediate

As your points of contact with the road, your tyres are probably one of the most important but also often neglected components on your bike.

Light weight and low rolling resistance might gain you a few seconds and seem an obvious choice but those gains will be lost and much more if you pick up a puncture. Follow this advice to get the best out of your rubber.

Tubulars, Clinchers or Tubeless

There’s no doubt there is something special about riding tubular tyres. They’re lighter, roll and ride better and you get fewer flats, as there’s no inner tube to pinch. However, for the majority of sportive riders, their expense, the hassle of glueing them and not being able to easily fix flats on the road, rules them out.

Traditional clincher tyres with an inner tube are by far the most popular and have improved massively. With a quality clincher and lightweight tube, the difference in weight and ride quality compared to a tubular is far more marginal than it used to be. Getting a flat with a clincher is a pain but is easy to sort out, needing just a couple of tyre levers, spare tube and a CO2 cartridge or a quality pump.

There is a third option, which is becoming increasingly popular. Tubeless clinchers originally come from mountain biking and use an airtight rim and liquid sealant to run without an inner tube. This reduces rotating mass, negates the risk of pinch flats and, with the sealant inside, penetration flats are instantly fixed. You can also carry an inner tube as an emergency standby. The downsides are a lack of choice of tyres and set-up or putting in a standby tube can be messy.


Look after your tyres and make checking them over part of your post ride routine. Wipe them off and look for any visible damage to the sidewalls or any significant gashes on the main tread. Take special care looking for and removing small stones, flints or glass that might have partially dug into the tread but not penetrated enough to cause a puncture. Do this after every ride and you’ll significantly increase the working life of your tyres and reduce the number of punctures you get.


Tyre pressure should be determined by rider weight, road conditions and weather. Don’t just mindlessly pump them up to their recommended maximum thinking that harder is always better. On a perfectly smooth surface a harder tyre will roll faster but even small imperfections on the road will cause an over-inflated tyre to skip and jump reducing rolling efficiency. A too hard tyre will also give a harsh and fatiguing ride and, on slippery roads, give less grip. Too soft and you’ll be making riding unnecessarily hard work and increasing your risk of punctures. Experiment with your tyre pressure until you find your ideal set-up. Consider running your rear tyre at a higher pressure (5-10 PSI) than your front and dropping pressure if it’s wet or if the roads are slippery or especially rough. Check your tyre pressure with an accurate gauge before every ride and don’t just assume that your tyres will have stayed inflated from last time.


With rotating weight a significant speed determinant, putting on super light tyres on race day might seem a no-brainer. Lightweight tyres are usually low on puncture protection and speeds gains can easily be wiped out by a flat. For rough British roads we’d always err on the side of more puncture protection and take the hit of a few extra grams.


Narrow doesn’t necessarily translate to fast. At the same pressure a wider tyre will roll better than a narrower one and current aerodynamic thinking is leaning towards wider tyres also. However narrower tyres will have a lower rotating mass making them easier to spin up to speed. An important consideration is that the ride quality of a narrower tyre will be harsher and on rough roads during a long ride this can be genuinely fatiguing. A 25C tyre width is a solid choice for most sportives.


Don’t be put off by smooth tyres as your grip comes from the tyre deforming to the lumps and bumps on the road and not from any tread pattern. Additionally, because of their profile, width, pressure and typical speed, bike tyres don’t have to channel water away from under them in the same way to a car’s tyres, most water is just pushed out to the side.


In wet conditions there is likely to be more debris on the road and, with the water acting as a lubricant for grit and other nasties to penetrate your rubber, punctures are far more common. If rain is expected, opt for a tyre with higher puncture protection. A softer rubber compound will give you more grip in the wet as will a wider tyre. Over the course of a long course race, especially in the UK, conditions can change massively so, a sensible all conditions tyre, is often your best bet.


If your approach is win or bust, PB or nothing, then gambling on super lightweight tyres might give you the edge you’re looking for. However, If you’ve trained hard, travelled and forked out on an entry fee, running marginally heavier but more durable tyres is definitely the sensible and probably the faster option.


Watch the team live